Search results
Results from the WOW.Com Content Network
A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation. The four main functions of a pipe support are to anchor, guide ...
The PV array consist of solar modules held in place by racks or frames that are attached to ground-based mounting supports. [11] [12] In general, ground mounted PV systems can be at the optimal tilt angle and orientation (as compared to roof mounted systems that can be non-optimal particularly for retrofits). Ground-based mounting supports include:
The copper pipe penetration is firestopped with firestop mortar. Riser clamp for a standpipe through-penetration firestop inside a fire hose cabinet under construction A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level.
In adjustable shelving systems, the bracket may be in two parts, with the load-bearing horizontal support fitting into a wall-mounted slotted vertical metal strip. Brackets also are an element in the systems used to mount modern facade cladding systems onto the outside of contemporary buildings, as well as interior panels.
A common type of this style fitting is a "hex bushing" with a hex head for installation with a pipe wrench. A double-tapped bushing is more compact than a reducer but not as flexible. While a double-tapped bushing has a more minor female thread concentric to a larger male thread (and thus couples a smaller male end to a larger female), a ...
External access point for fire sprinkler and dry standpipe at a building in San Francisco, US Antique wet standpipe preserved at Edison and Ford Winter Estates. A standpipe or riser is a type of rigid water piping which is built into multi-story buildings in a vertical position, or into bridges in a horizontal position, to which fire hoses can be connected, allowing manual application of water ...
A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).
Powell v. The Home Depot USA, Inc., 663 F.3d 1221 (Fed. Cir. 2011), [1] was a decision by the United States Court of Appeals for the Federal Circuit on the issue of patent infringement on a "safe hands" device that Michael Powell, an independent contractor for Home Depot, created in response to injuries to the hands of associates using in-store radial arm saws.