enow.com Web Search

  1. Ad

    related to: i2c vs serial clock parts

Search results

  1. Results from the WOW.Com Content Network
  2. I²C - Wikipedia

    en.wikipedia.org/wiki/I²C

    Clock stretching is the only time in I 2 C where the target drives SCL. Many targets do not need to clock stretch and thus treat SCL as strictly an input with no circuitry to drive it. Some controllers, such as those found inside custom ASICs may not support clock stretching; often these devices will be labeled as a "two-wire interface" and not ...

  3. System Management Bus - Wikipedia

    en.wikipedia.org/wiki/System_Management_Bus

    It carries clock, data, and instructions and is based on Philips' I²C serial bus protocol. [1] Its clock frequency range is 10 kHz to 100 kHz. (PMBus extends this to 400 kHz.) Its voltage levels and timings are more strictly defined than those of I²C, but devices belonging to the two systems are often successfully mixed on the same bus.

  4. Management Data Input/Output - Wikipedia

    en.wikipedia.org/wiki/Management_Data_Input/Output

    Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...

  5. Serial communication - Wikipedia

    en.wikipedia.org/wiki/Serial_communication

    The communication links, across which computers (or parts of computers) talk to one another, may be either serial or parallel. A parallel link transmits several streams of data simultaneously along multiple channels (e.g., wires, printed circuit tracks, or optical fibers); whereas, a serial link transmits only a single stream of data.

  6. Asynchronous serial communication - Wikipedia

    en.wikipedia.org/wiki/Asynchronous_serial...

    Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...

  7. Universal synchronous and asynchronous receiver-transmitter

    en.wikipedia.org/wiki/Universal_synchronous_and...

    The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.

  8. Synchronous Serial Interface - Wikipedia

    en.wikipedia.org/wiki/Synchronous_Serial_Interface

    Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.

  9. Synchronous serial communication - Wikipedia

    en.wikipedia.org/wiki/Synchronous_serial...

    Synchronous serial communication describes a serial communication protocol in which "data is sent in a continuous stream at constant rate." [1]Synchronous communication requires that the clocks in the transmitting and receiving devices are synchronized – running at the same rate – so the receiver can sample the signal at the same time intervals used by the transmitter.

  1. Ad

    related to: i2c vs serial clock parts