Search results
Results from the WOW.Com Content Network
The heat dissipation in integrated circuits problem has gained an increasing interest in recent years due to the miniaturization of semiconductor devices. The temperature increase becomes relevant for cases of relatively small-cross-sections wires, because such temperature increase may affect the normal behavior of semiconductor devices.
The thermoelectric effect is the direct conversion of temperature differences to electric voltage and vice versa via a thermocouple. [1] A thermoelectric device creates a voltage when there is a different temperature on each side.
The efficiency of a thermoelectric device for electricity generation is given by , defined as =.. The maximum efficiency of a thermoelectric device is typically described in terms of its device figure of merit where the maximum device efficiency is approximately given by [7] = + ¯ + ¯ +, where is the fixed temperature at the hot junction, is the fixed temperature at the surface being cooled ...
The typical efficiency of TEGs is around 5–8%, although it can be higher. Older devices used bimetallic junctions and were bulky. More recent devices use highly doped semiconductors made from bismuth telluride (Bi 2 Te 3), lead telluride (PbTe), [10] calcium manganese oxide (Ca 2 Mn 3 O 8), [11] [12] or combinations thereof, [13] depending on application temperature.
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
The term "hot electron" comes from the effective temperature term used when modelling carrier density (i.e., with a Fermi-Dirac function) and does not refer to the bulk temperature of the semiconductor (which can be physically cold, although the warmer it is, the higher the population of hot electrons it will contain all else being equal).
A semiconductor is a material that is between the conductor and insulator in ability to conduct electrical current. [1] In many cases their conducting properties may be altered in useful ways by introducing impurities ("doping") into the crystal structure.
The Seebeck coefficient (also known as thermopower, [1] thermoelectric power, and thermoelectric sensitivity) of a material is a measure of the magnitude of an induced thermoelectric voltage in response to a temperature difference across that material, as induced by the Seebeck effect. [2]