enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Strip-built - Wikipedia

   en.wikipedia.org/wiki/Strip-built

   Strip-built, or "strip-plank epoxy", is a method of boat building. [1] Also known as cold molding, the strip-built method is commonly used for canoes and kayaks, but also suitable for larger boats. The process involves securing narrow, flexible strips of wood edge-to-edge around temporary formers.

3. Epoxy - Wikipedia

   en.wikipedia.org/wiki/Epoxy

   Epoxy coatings are also widely used as primers to improve the adhesion of automotive and marine paints especially on metal surfaces where corrosion (rusting) resistance is important. Metal cans and containers are often coated with epoxy to prevent rusting, especially for foods like tomatoes that are acidic .

4. Anti-fouling paint - Wikipedia

   en.wikipedia.org/wiki/Anti-fouling_paint

   New ship being prepared for launch, showing fresh anti-fouling paint Ship hull being cleaned of fouling in drydock. Anti-fouling paint is a specialized category of coatings applied as the outer (outboard) layer to the hull of a ship or boat, to slow the growth of and facilitate detachment of subaquatic organisms that attach to the hull and can affect a vessel's performance and durability.

5. Stitch and glue - Wikipedia

   en.wikipedia.org/wiki/Stitch_and_glue

   The one sheet boat (OSB, cf. oriented strand board) is an outgrowth of the stitch and glue technique. The OSB is a boat that can be built using a single sheet of 4 foot by 8 foot plywood (1.22 m × 2.44 m). Some additional wood is often used, for supports, chines, or as a transom, though some can be built entirely with the sheet of plywood ...

6. Corrosion in ballast tanks - Wikipedia

   en.wikipedia.org/wiki/Corrosion_in_ballast_tanks

   Temperatures in this area are much lower due to the cooling of the sea. If this extremely cathodic region is placed close to an anodic source (e.g. a corroding ballast pipe), cathodic blistering may occur especially where the epoxy coating is relatively new. Mud retained in ballast water can lead to microbial corrosion. [4]

7. Top Hat 25 - Wikipedia

   en.wikipedia.org/wiki/Top_Hat_25

   Later a chopper gun was used to apply most of the joining laminate and stringer placement. The keel was made from hand laid lead ingots with lead shot and resin used to form a homogeneous mass. This was topped with fibreglass and an epoxy coating was applied with the top forming the cabin sole and the space used between the two as a water tank.