enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw terminal - Wikipedia

   en.wikipedia.org/wiki/Screw_terminal

   Two paired screw terminals, typically used for connecting ceiling-mounted light fixtures. Screw terminals are used extensively in building wiring for the distribution of electricity - connecting electrical outlets, luminaires and switches to the mains, and for directly connecting major appliances such as clothes dryers and ovens drawing in excess of 15 amperes.

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

4. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

5. IEC metric screw sized connectors - Wikipedia

   en.wikipedia.org/wiki/IEC_metric_screw_sized...

   The number gives their outer screw thread diameter in millimeters as with the identically named screws. However, the connectors are further classified by a so-called coding, denoted by one or more letters, which defines things like pin layout, shape of connecting surfaces and electrical properties. [2] [3]

6. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...

7. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   B18.6.1 Wood Screws (Inch Series) B18.6.2 Slotted Head Cap Screws, Square Head Set Screws, And Slotted Headless Set Screws (Inch Series) B18.6.3 Machine Screws, Tapping Screws, and Metallic Drive Screws (Inch Series) B18.18 Quality Assurance For Fasteners; B18.24 Part Identifying Number (PIN) Code System Standard for B18 Fastener Products