Ads
related to: cantilever sliding gate plans
Search results
Results from the WOW.Com Content Network
A sliding electric gate with electric motor and backup battery in case of mains failure. Note also the Infrared obstacle sensor located on the wall to prevent the gate from closing while a vehicle or other obstacle is in the way.
This design has been pioneered by the structural engineer Santiago Calatrava in 1992 with the Puente del Alamillo in Seville, Spain. In two of his designs the force distribution does not depend solely upon the cantilever action of the spar (pylon); the angle of the spar away from the bridge and the weight distribution in the spar serve to ...
A cantilever bridge is a bridge built using structures that project horizontally into space, supported on only one end (called cantilevers).For small footbridges, the cantilevers may be simple beams; however, large cantilever bridges designed to handle road or rail traffic use trusses built from structural steel, or box girders built from prestressed concrete.
Cantilever wings require much stronger and heavier spars than would otherwise be needed in a wire-braced design. However, as the speed of the aircraft increases, the drag of the bracing increases sharply, while the wing structure must be strengthened, typically by increasing the strength of the spars and the thickness of the skinning.
A swing bridge (or swing span bridge) is a movable bridge that can be rotated horizontally around a vertical axis. It has as its primary structural support a vertical locating pin and support ring, usually at or near to its center of gravity, about which the swing span (turning span) can then pivot horizontally as shown in the animated illustration to the right.
The Hart Bridge is a continuous, cantilevered truss bridge with an unusual design that includes a suspended road deck on the 332-metre (1,088 ft) main span and a through truss deck on the adjacent approach spans. Some notable continuous truss bridges, with main span lengths.
A road sign indicating a bascule bridge ahead. There are three types of bascule bridge [1] and the counterweights to the span may be located above or below the bridge deck.. The fixed-trunnion (sometimes a "Chicago" bascule) rotates around a large axle that raises the span(s).
A simple suspension bridge (also rope bridge, swing bridge (in New Zealand), suspended bridge, hanging bridge and catenary bridge) is a primitive type of bridge in which the deck of the bridge lies on two parallel load-bearing cables that are anchored at either end.
Ads
related to: cantilever sliding gate plans