Search results
Results from the WOW.Com Content Network
The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale. Thus on an architect's drawing one might read 'one centimeter to one meter', 1:100, 1/100, or 1 / 100 . A bar scale would also normally appear on the drawing.
The 1976 device is an extruded aluminum bar, 36 inches (91 cm) long and 1.75 inches (4.4 cm) wide, with a 145° V-shaped groove extending along its entire length, supporting the ball at two points, 0.50 in (1.27 cm) apart. It is tapered at one end by removing metal from its underside to reduce the bounce of the ball as it rolls onto the green.
A graphical or bar scale. A map would also usually give its scale numerically ("1:50,000", for instance, means that one cm on the map represents 50,000cm of real space, which is 500 meters) A bar scale with the nominal scale expressed as "1:600 000", meaning 1 cm on the map corresponds to 600,000 cm=6 km on the ground.
An engineer's scale is a tool for measuring distances and transferring measurements at a fixed ratio of length. It is commonly made of plastic or aluminum and is just over 300 millimetres (12 in) long, but with the only 300 mm of markings, leaving the ends unmarked so that the first and last measuring ticks do not wear off.
The length of the line on the linear scale is equal to the distance represented on the earth multiplied by the map or chart's scale. In most projections, scale varies with latitude, so on small scale maps, covering large areas and a wide range of latitudes, the linear scale must show the scale for the range of latitudes covered by the map. One ...
The earth atmosphere's scale height is about 8.5 km, as can be confirmed from this diagram of air pressure p by altitude h: At an altitude of 0, 8.5, and 17 km, the pressure is about 1000, 370, and 140 hPa, respectively.
Miller Moss, who began the season as USC's starting quarterback, is entering the transfer portal. Moss posted a statement on Monday declaring his intentions to enter the portal as a graduate ...
A height gauge is a measuring device used for determining the height of objects, and for marking of items to be worked on. [ 1 ] These measuring tools are used in metalworking or metrology to either set or measure vertical distances; [ citation needed ] the pointer is sharpened to allow it to act as a scriber and assist in marking out work pieces.