Search results
Results from the WOW.Com Content Network
In contrast, a linear power supply regulates the output voltage by continually dissipating power in the pass transistor. The switched-mode power supply's higher electrical efficiency is an important advantage. Switched-mode power supplies can also be substantially smaller and lighter than a linear supply because the transformer can be much smaller.
The following group of digits indicate the power: Backward-wave amplifier or Traveling-wave tube: Output power; 2nd letter: A – in mW; 2nd letter: B – in W; Klystrons: Output power in W; Reflex Klystrons: Output power in mW; Magnetrons: Pulse output power in kW; Continuously transmitting tubes: Maximum anode dissipation in W or kW in Class ...
A full-wave rectifier converts the whole of the input waveform to one of constant polarity (positive or negative) at its output. Mathematically, this corresponds to the absolute value function. Full-wave rectification converts both polarities of the input waveform to pulsating DC (direct current), and yields a higher average output voltage.
Typical HT supply circuit schematic. The HT supply was usually obtained from a full wave rectifier circuit similar to the one shown. In those sets that had no mains transformer (the so-called AC/DC design), the HT was obtained directly from the mains supply, either with a simple half wave rectifier or with a voltage doubler circuit.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
Mercury rectifier on display in the Beromünster AM transmitter in Switzerland, before being decommissioned.Three-phase full-wave rectifier with six anodes. A mercury-arc valve or mercury-vapor rectifier or (UK) mercury-arc rectifier [1] [2] is a type of electrical rectifier used for converting high-voltage or high-current alternating current (AC) into direct current (DC).
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
In switch-mode power supplies, the control circuits are powered from the output. To start the power supply, a leakage resistance can be used to trickle-charge the supply rail for the control circuit to start it oscillating. This approach is less costly and simpler than providing a separate linear power supply just to start the regulator circuit ...