Search results
Results from the WOW.Com Content Network
An automatic transmission with a manumatic function provides a greater level of control by allowing the driver to request an upshift or downshift at a specific time. This is usually achieved using "+" and "-" positions on the gear selector or with paddle-shifters mounted beside the steering wheel.
Tremec T-5 — 5-speed longitudinal manual currently made by Tremec; originally made by Borg-Warner; Borg-Warner R-10 overdrive - 3-speed manual transmission with electric overdrive used 1937-1964; Borg-Warner R-11 overdrive - 3-speed manual transmission with electric overdrive Ford used them up until 1975 in trucks.
In December 2020, GM initiated a program to repair or replace 9T65 transmissions which were causing issues. Repairs were limited to external components only. [12] The program applied to vehicles that had less than 18,000 mi (29,000 km) and had been delivered within the past 18 months. [13]
The Hydra-Matic 6T40 and similar 6T30, 6T45, and 6T50 are transversely-mounted six speed automatic transmissions produced by General Motors.The 6T40, referred to in GM inner circles as the GF6, made its debut in the 2008 Chevrolet Malibu, available with the 2.4 L LE5 Ecotec engine making 164 horsepower (122 kW), and has since also been made available on the Chevrolet Cruze, Daewoo Tosca and ...
1946–1953 M5/M6 Presto-Matic — 4-speed (2 gear manual with electric overdrive) with clutch and fluid coupling (Fluid Drive) or torque converter (Fluid Torque Drive); also known as Tip-Toe Shift, Gyro-Matic, Fluid-Matic, Gyro-Torque; 1953–1954 Hy-Drive — 3-speed manual transmission behind a torque converter
The 2012-2016 DPS6 Powershift transmission was used in the 2012–2016 Ford Focus and 2011–2016 Ford Fiesta sedans. This transmission is the subject of a massive number of lawsuits alleging Ford lied in order to sell cars Ford knew had defective transmissions. [8] 2008–present 6DCT450 Ford Powershift (MPS6) 6-speed wet clutch
Basically there are two types of motor vehicle transmissions: Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load
Preselector gearboxes were most common prior to the widespread adoption of the automatic transmission, so they were considered in comparison to the "crash gearbox" type of manual transmission. Preselector gearboxes were often marketed as "self-changing" gearboxes, [ 1 ] however this is an inaccurate description as the driver is required to ...