Search results
Results from the WOW.Com Content Network
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
The configuration software of choice is then used to configure the persistent configuration which is applied on boot. It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip: [10]
IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing and queued to the appropriate outgoing interface according to their destination address and a set of rules and performance metrics.
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes.
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...
Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...
Otherwise, it will take precedence over all routing protocols and routes issued from a routing protocol will not be inserted into the routing table. [3] The example below shows how to configure the administrative distance to 254 to specify that it should only be used as a last resort. R1(config)# ip route 10.0.0.0 255.0.0.0 backupLink 1 254
For example, the U flag indicates that an IP route is up. filtering criteria: Access-control lists associated with the route; interface: Such as eth0 for the first Ethernet card, eth1 for the second Ethernet card, etc. Shown below is an example of what the table above could look like on a computer connected to the internet via a home router: