Ads
related to: small scale steam generator engine
Search results
Results from the WOW.Com Content Network
Edward "Ted" Pritchard (28 August 1930 – 16 August 2007) was an Australian mechanical engineer, inventor and developer of small scale modern steam engines.Pritchard was obsessed by the virtues of modern steam as compared to the internal combustion engine.
An engine–generator is the combination ... This can be a steam engine, ... Engine-driven generators fueled on natural gas fuel often form the heart of small-scale ...
A small, horizontal, single-cylinder steam engine, bore 0.75 inches, stroke 0.75 inches, length 6.5 inches. This has a trunk guide so the crosshead is equally supported for either direction of rotation. [40] D10 A small twin-cylinder vertical steam engine (based on 10V), bore 0.75 inches, stroke 0.75 inches, standing 6.5 inches high. [41] Score
Type of steam generator unit used in coal-fired power plants. The steam generator or steam boiler is an integral component of a steam engine when considered as a prime mover. However it needs to be treated separately, as to some extent a variety of generator types can be combined with a variety of engine units.
1) Feedwater pump 2) Boiler or steam generator 3) Turbine or engine 4) Condenser; where Q=heat and W=work. Most of the heat is rejected as waste. The Rankine cycle is the fundamental thermodynamic underpinning of the steam engine.
Turbo generators are used for high shaft rotational speeds, typical of steam and gas turbines. The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz).
The MT are 25 to 500 kW (34 to 671 hp) gas turbines evolved from piston engine turbochargers, aircraft auxiliary power units (APU) or small jet engines, the size of a refrigerator. [2] Early turbines of 30–70 kW (40–94 hp) grew to 200–250 kW (270–340 hp).
The Cyclone Engine is built of three major components, the Steam Generator, Piston Block, and Condenser. The working fluid, deionized water, travels continuously through these three components. Beginning in the steam generator, moving into the pistons, then to the condenser, and finally pumped back into the steam generator. [29]
Ads
related to: small scale steam generator engine