enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Decibel - Wikipedia

    en.wikipedia.org/wiki/Decibel

    The decibel (symbol: dB) is a relative unit of measurement equal to one tenth of a bel (B). It expresses the ratio of two values of a power or root-power quantity on a logarithmic scale. Two signals whose levels differ by one decibel have a power ratio of 10 1/10 (approximately 1.26) or root-power ratio of 10 1/20 (approximately 1.12). [1] [2]

  3. Signal strength in telecommunications - Wikipedia

    en.wikipedia.org/wiki/Signal_strength_in...

    For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu). Examples. 100 dBμ or 100 mV/m: blanketing interference may occur on some receivers

  4. dBFS - Wikipedia

    en.wikipedia.org/wiki/DBFS

    Clipping of a digital waveform. The red lines indicate full scale, and the waveform is shown before and after hard clipping (grey and black outlines respectively). Decibels relative to full scale (dBFS or dB FS) is a unit of measurement for amplitude levels in digital systems, such as pulse-code modulation (PCM), which have a defined maximum ...

  5. dBm - Wikipedia

    en.wikipedia.org/wiki/DBm

    dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...

  6. EBU R 128 - Wikipedia

    en.wikipedia.org/wiki/EBU_R_128

    Loudness Units referenced to full scale Loudness measurement unit on an absolute scale, K-weighted, [3] relative to a digital scale (the upper limit of which is 0 dBFS). Equivalent with LKFS, used in ITU-R BS.1770. LU Loudness Unit Relative loudness measurement. 1 LU corresponds to the relative measurement of 1 dB on a digital scale. LU can ...

  7. Signal-to-noise ratio - Wikipedia

    en.wikipedia.org/wiki/Signal-to-noise_ratio

    Each extra quantization bit increases the dynamic range by roughly 6 dB. Assuming a full-scale sine wave signal (that is, the quantizer is designed such that it has the same minimum and maximum values as the input signal), the quantization noise approximates a sawtooth wave with peak-to-peak amplitude of one quantization level [11] and uniform ...

  8. dBc - Wikipedia

    en.wikipedia.org/wiki/DBc

    dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...

  9. Dynamic range - Wikipedia

    en.wikipedia.org/wiki/Dynamic_range

    Vinyl microgroove phonograph records typically yield 55-65 dB, though the first play of the higher-fidelity outer rings can achieve a dynamic range of 70 dB. [25] German magnetic tape in 1941 was reported to have had a dynamic range of 60 dB, [26] though modern-day restoration experts of such tapes note 45-50 dB as the observed dynamic range. [27]