Search results
Results from the WOW.Com Content Network
Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude. The change of atmospheric pressure with altitude can be obtained from this equation: [2]
mg/m 3 = milligrams of pollutant per cubic meter of air at sea level atmospheric pressure and T: ppmv = air pollutant concentration, in parts per million by volume T = ambient temperature in K = 273. + °C 0.082057338 = Universal gas constant in L atm mol −1 K −1: M = molecular mass (or molecular weight) of the air pollutant
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
Criteria can be set in different units (e.g. μg/m 3, parts per billion by volume (ppbv), parts per billion by mass (ppb (mass)), parts per million (ppm)) and it is possible to convert between all of these units if the molecular mass of the pollutant and the temperature are known. Different standard temperatures are used throughout the world ...
Chemical regulation is sometimes [clarification needed] expressed in parts per million (ppm), but often [clarification needed] in milligrams per cubic meter (mg/m 3). [2] Units of measure for physical agents such as noise are specific to the agent.
The following guideline values (ppm values rounded) and periods of time-weighted average exposures have been determined in such a way that the carboxyhemoglobin (COHb) level of 2.5% is not exceeded, even when a normal subject engages in light or moderate exercise: 100 mg/m 3 (87 ppm) for 15 min; 60 mg/m 3 (52 ppm) for 30 min; 30 mg/m 3 (26 ppm ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
In the table above, the LOCATION means where the Coalescing Filter is relative to Refrigerated Air Dryer. 1 mg/m3 is a weight of oil in a volume of air and is approximately equal to 0.83 ppm by weight. [11] High temperature dryers are equipped with an additional pre-cooler that removes excess heat via a forced air system.