enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Garden hose - Wikipedia

   en.wikipedia.org/wiki/Garden_hose

   The US standard was defined by NFPA 1963, "Standard for Fire Hose Connections", [2] then later by ANSI-ASME B1.20.7, [3] which specifies 1 + 1 ⁄ 16 inches (27 mm) diameter straight (non-tapered) thread with a pitch of 11.5 threads per inch (TPI). The female thread is abbreviated FHT (for "female hose thread"), and the male part is abbreviated ...

3. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   A hose coupling is a connector on the end of a hose to connect (or couple) it with another hose or with a tap or a hose appliance, such as an irrigation sprinkler. It is usually made of steel , brass , stainless steel , aluminium or plastic .

4. Fire hose - Wikipedia

   en.wikipedia.org/wiki/Fire_hose

   It should also be strong enough to resist hydrant pressure. Usually an appliance has to carry about 10 m of suction hose in either 3 m or 2.5 m length. The diameter of the hose depends on the capacity of the pump, and three standard sizes such as 75mm, 100mm, and 140mm are generally used. Partially Embedded suction hose

5. Hard suction hose - Wikipedia

   en.wikipedia.org/wiki/Hard_suction_hose

   5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.

6. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]