Search results
Results from the WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles.
Highly decorative wood-shingle siding on a house in Clatskanie, Oregon, U.S. Siding or wall cladding is the protective material attached to the exterior side of a wall of a house or other building. Along with the roof, it forms the first line of defense against the elements, most importantly sun, rain/snow, heat and cold, thus creating a stable ...
Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1]
Veneer refers to thin slices of wood and sometimes bark that typically are glued onto core panels (typically, wood, particle board or medium-density fiberboard) to produce flat panels such as doors, tops and panels for cabinets, parquet floors and parts of furniture. They are also used in marquetry. Plywood consists of three or more layers of ...
Cement board can be nailed or screwed to wood or steel studs to create a substrate for vertical tile and attached horizontally to plywood for tile floors, kitchen counters and backsplashes. It can be used on the exterior of buildings as a base for exterior plaster ( stucco ) systems and sometimes as the finish system itself.
Some SIPs use fiber-cement or plywood sheets for the panels, and agricultural fiber, such as wheat straw, for the core. The third component in SIPs is the spline or connector piece between SIPs. Dimensional lumber is commonly used but creates thermal bridging and lowers insulation values.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Depending on the desired look of the floor, the timber can be cut in three ways: flat-sawn, quarter-sawn, and rift-sawn. The timber is cut to the desired dimensions and either packed unfinished for a site-finished installation or finished at the factory.