enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.

3. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Single-pole circuit breakers feed 120 V circuits from one of the 120 V buses within the panel, or two-pole circuit breakers feed 240-volt circuits from both buses. 120 V circuits are the most common, and used to power NEMA 1 and NEMA 5 outlets, and most residential and light commercial direct-wired lighting circuits.

4. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...

5. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   Consecutive AWG wire sizes thicker than No. 1 wire are designated by the number of zeros: No. 0, often written 1/0 and referred to as "one aught" wire; No. 00, often written 2/0 and referred to as "two aught" wire; No. 000, often written 3/0 and referred to as "three aught" wire; and so on.

6. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The standard includes preferred current ratings and wire gauges for both International (deemed Series I) and North American (deemed Series II) applications. Series I preferred current ratings (in amps) are: 16, 32, 63, 125, 250, 400, 630 and 800, with wire gauges specified as mm 2 .

7. High-leg delta - Wikipedia

   en.wikipedia.org/wiki/High-leg_delta

   Even when unmarked, it is generally easy to identify this type of system, because the B phase (circuits #3 and #4) and every third circuit afterwards will be either a three-pole breaker or a blank. Current practice is to give separate services for single-phase and three-phase loads, e.g., 120 V split-phase (lighting etc.) and 240 V to 600 V ...