enow.com Web Search

  1. Ads

    related to: 1 4 boat drain plug

Search results

  1. Results from the WOW.Com Content Network
  2. Oakum - Wikipedia

    en.wikipedia.org/wiki/Oakum

    In 1862, girls under 16 at Tothill Fields Bridewell had to pick 1 pound (450 g) a day, and boys under 16 had to pick 1 + 1 ⁄ 2 pounds (680 g). [4] Over the age of 16, girls and boys had to pick 1 + 1 ⁄ 2 and 2 pounds (680 and 910 g) per day respectively. [4] The oakum was sold for £4 10s (equivalent to £559 in 2023) per hundredweight (112 ...

  3. Bluejacket 23 - Wikipedia

    en.wikipedia.org/wiki/Bluejacket_23

    The Paceship Bluejacket 23 is a small recreational keelboat.It has a fractional rig, a spade rudder, and a fixed fin keel.The boat has a draft of 3.75 ft (1.14 m). [1] It displaces 2,000 lb (907 kg) and carries 900 lb (408 kg) of iron ballast.

  4. Longship - Wikipedia

    en.wikipedia.org/wiki/Longship

    A drain plug hole about 25 mm (1 inch) was drilled in the garboard plank on one side to allow rain water drainage. The oars did not use rowlocks or thole pins but holes cut below the gunwale line. To keep seawater out, these oar holes were sealed with wooden disks from the inside, when the oars were not in use.

  5. Scupper - Wikipedia

    en.wikipedia.org/wiki/Scupper

    A scupper is an opening in the side walls of a vessel or an open-air structure, which allows water to drain instead of pooling within the bulwark or gunwales of a vessel, or within the curbing or walls of a building. Ship's bulwark. 1. Gunwale, 2. Bulwark plating, 3. Flange, 4. Stanchion, 5. Stringer plate, 6. Stringer angle, 7. Sheerstrake.

  6. Limber hole - Wikipedia

    en.wikipedia.org/wiki/Limber_hole

    A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge. Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors.

  7. Seacock - Wikipedia

    en.wikipedia.org/wiki/Seacock

    The reason for this is that when the boat is level, the drain or other opening will always be above the waterline, and so water will only flow out. At sea, when the boat rolls in the waves, the opening may sometimes be below the waterline. If the seacock is open, water may flood the boat, causing it to sink. Sea valve at lower right

  1. Ads

    related to: 1 4 boat drain plug