Search results
Results from the WOW.Com Content Network
English: 24-pin ATX power plug, from a Seasonic ATX PSU; pins 11, 12, 23 and 24 form a detachable separate four-pin plug, making it backward compatible with 20-pin ATX receptacles. Date 5 November 2013, 00:46
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin, i.e. 20+4-pin form) which can be used together to form the 24-pin connector.
In 20/24-pin configurations, the Mini-Fit Jr. connector (Molex Mini-fit Jr. 39-28-1203, [7] former 5566-20A or 39-28-1243, [8] former 5566-24A) may be used on ATX motherboards as the main power connector. The same style of connector, in single or paired 4-, 6-, or 8-pin configurations, may be used for additional CPU power and graphics card ...
A 20 % shorter variant of the ATX form factor. Compatible with most ATX cases, but has fewer slots than ATX, for a smaller power supply unit. Very popular for desktop and small form factor computers as of 2017. Mini-ATX: AOpen: 2005 150 × 150 mm (5.9 × 5.9 in) Mini-ATX is considerably smaller than Micro-ATX.
Mini-ITX 2.0 SoC mainboard with ATX12V connector installed in a Micro-ATX computer case. The Mini-ITX standard does not define a standard for the computer power supply, though it suggests possible options. Conventionally Mini-ITX boards use a 20- or 24-pin "original ATX" power connector.
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).