enow.com Web Search

  1. Ad

    related to: dampened front sprocket system definition

Search results

  1. Results from the WOW.Com Content Network
  2. MacPherson strut - Wikipedia

    en.wikipedia.org/wiki/MacPherson_strut

    The MacPherson strut is a type of automotive suspension system that uses the top of a telescopic damper as the upper steering pivot. It is widely used in the front suspension of modern vehicles. The name comes from American automotive engineer Earle S. MacPherson, who invented and developed the design.

  3. Car suspension - Wikipedia

    en.wikipedia.org/wiki/Car_suspension

    The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...

  4. List of bicycle parts - Wikipedia

    en.wikipedia.org/wiki/List_of_bicycle_parts

    Cassette: a group of stacked sprockets on the rear wheel of a bicycle with a rear derailleur; Coaster brake or backpedal brake; Chain: a system of interlinking pins, plates and rollers that transmits power from the front sprocket(s) to the rear sprocket(s)

  5. Sprocket - Wikipedia

    en.wikipedia.org/wiki/Sprocket

    The sprocket wheels a, b, and c engage and transport the film. a and b move with uniform velocity and c indexes each frame of the film into place for projection. Sprockets are used in the film transport mechanisms of movie projectors and movie cameras. [5] In this case, the sprocket wheels engage film perforations in the film stock.

  6. Harmonic damper - Wikipedia

    en.wikipedia.org/wiki/Harmonic_damper

    The damper will be fitted at the front of the engine (opposite the clutch or transmission) just beyond the cover of the timing chain, gears, or belt, and behind the accessory drive pulley (which may carry one or more V, serpentine, or cogged belts.) In older vehicles the pulley and damper were separate units that were bolted together.

  7. Pull-rod suspension - Wikipedia

    en.wikipedia.org/wiki/Pull-rod_suspension

    In a push-rod system, the rocker arms are placed at the highest point in the assembly. As such, the rod is under pressure as it transfers compression forces upwards into the rocker arms. In a pull-rod system however, the rocker arms are located between the upper and lower control arms, at the centre of the assembly.

  8. Damping - Wikipedia

    en.wikipedia.org/wiki/Damping

    The damping ratio is a system parameter, denoted by ζ ("zeta"), that can vary from undamped (ζ = 0), underdamped (ζ < 1) through critically damped (ζ = 1) to overdamped (ζ > 1). The behaviour of oscillating systems is often of interest in a diverse range of disciplines that include control engineering , chemical engineering , mechanical ...

  9. Bicycle gearing - Wikipedia

    en.wikipedia.org/wiki/Bicycle_gearing

    Front/rear gear measurement uses two numbers (e.g. 53/19) where the first is the number of teeth in the front chainring and the second is the number of teeth in the rear sprocket. Without doing some arithmetic, it is not immediately obvious that 53/19 and 39/14 represent effectively the same gear ratio.

  1. Ad

    related to: dampened front sprocket system definition