enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Pore pressure gradient - Wikipedia

    en.wikipedia.org/wiki/Pore_pressure_gradient

    Using the figures above, we can calculate the maximum pressure at various depths in an offshore oil well. Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal)

  3. Orders of magnitude (pressure) - Wikipedia

    en.wikipedia.org/wiki/Orders_of_magnitude_(pressure)

    3,200 psi Critical pressure of water 28 MPa 4,100 psi Overpressure caused by the bomb explosion during the Oklahoma City bombing [72] 40 MPa 5,800 psi Water pressure at the depth of the wreck of the Titanic: 69 MPa 10,000 psi Water pressure withstood by the DSV Shinkai 6500 in visiting ocean depths of > 6500 meters [73] 70 to 280 MPa 10,000 to ...

  4. Pressure tank - Wikipedia

    en.wikipedia.org/wiki/Pressure_tank

    Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V. Referring to the diagram on the right, a pressure tank is generally pressurized when empty with a "charging pressure" P c, which is usually about 2 psi below the turn-on pressure P lo (Case 1). The total volume of the tank is V t.

  5. Well control - Wikipedia

    en.wikipedia.org/wiki/Well_control

    Subnormal pore pressure is defined as any formation pressure that is less than the corresponding fluid hydrostatic pressure at a given depth. [6] Subnormally pressured formations have pressure gradients lower than fresh water or less than 0.433 psi/ft (0.0979 bar/m).

  6. Fuel bladder - Wikipedia

    en.wikipedia.org/wiki/Fuel_bladder

    Standard fuel bladder tanks sizes range from 100-US-gallon (380 L) to 200,000-US-gallon (760,000 L) capacities and larger. Custom fuel storage bladders and cells are available, although at sizes exceeding 50,000 US gallons (190,000 L) there is an increased spill risk.

  7. Pore water pressure - Wikipedia

    en.wikipedia.org/wiki/Pore_water_pressure

    When there is no flow, the pore pressure at depth, h w, below the water surface is: [4] =, where: p s is the saturated pore water pressure (kPa) g w is the unit weight of water (kN/m 3), = / [5] h w is the depth below the water table (m),

  8. Water (data page) - Wikipedia

    en.wikipedia.org/wiki/Water_(data_page)

    In the following table, material data are given with a pressure of 611.7 Pa (equivalent to 0.006117 bar). Up to a temperature of 0.01 °C, the triple point of water, water normally exists as ice, except for supercooled water, for which one data point is tabulated here. At the triple point, ice can exist together with both liquid water and vapor.

  9. Pound per square inch - Wikipedia

    en.wikipedia.org/wiki/Pound_per_square_inch

    For example, a bicycle tire pumped up to 65 psig in a local atmospheric pressure at sea level (14.7 psi) will have a pressure of 79.7 psia (14.7 psi + 65 psi). [ 2 ] [ 3 ] When gauge pressure is referenced to something other than ambient atmospheric pressure, then the unit is pound per square inch differential ( psid ).