Search results
Results from the WOW.Com Content Network
The rule affected only those aircraft operating under IFR when in level flight above 3,000 ft above mean sea level, or above the appropriate transition altitude, whichever is the higher, and when below FL195 (19,500 ft above the 1013.2 hPa datum in the UK, or with the altimeter set according to the system published by the competent authority in ...
In a typical commercial passenger flight, the cabin altitude is programmed to rise gradually from the altitude of the airport of origin to a regulatory maximum of 8,000 ft (2,438 m). This cabin altitude is maintained while the aircraft is cruising at its maximum altitude and then reduced gradually during descent until the cabin pressure matches ...
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
A Qantas four-engined Boeing 747-400 at cruise altitude. Cruise is the phase of aircraft flight that starts when the aircraft levels off after a climb, until it begins to descend for landing. [1] Cruising usually comprises the majority of a flight, and may include small changes in heading (direction of flight), airspeed, and altitude.
En-route charts are divided into high and low versions, with information on airways and navaids for high- and low-altitude flight, respectively. The division between low altitude and high altitude is usually defined as the altitude that marks transition to flight levels (in the United States , this is taken to be 18,000 feet MSL by convention).
Here’s what you can expect to pay, on average, for air travel within the U.S. Skip to main content. 24/7 Help. For premium support please call: 800-290-4726 more ways to ...
The service ceiling is the maximum altitude of an aircraft during normal operations. Specifically, it is the density altitude at which flying in a clean configuration , at the best rate of climb airspeed for that altitude and with all engines operating and producing maximum continuous power, will produce a given rate of climb.
In Australia, Visual Navigation Charts (VNCs) and Visual Terminal Charts (VTCs) usually indicate MEF information by use of bold elevation figures for each grid. Pilots are also required to ensure their planned route does not contravene the minimum flying altitude regulations contained in CAR 167. This restriction is normally 1000FT above ...