Search results
Results from the WOW.Com Content Network
For a flow calculation, a depth measurement both upstream and downstream is needed. Although commonly thought of as occurring at higher flow rates, submerged flow can exist at any flow level as it is a function of downstream conditions. In natural stream applications, submerged flow is frequently the result of vegetative growth on the ...
Drill stem testing is an oil and gas exploration procedure to isolate, stimulate and flow a downhole formation to determine the fluids present and the rate at which they can be produced. The main objective of a DST is to evaluate the commercial viability of a zone's economic potential by identifying productive capacity, pressure, permeability ...
Conventional airlift pumps have a flow rate that is very limited. The pump is either on or off. It is very difficult to get a wide range of proportional flow control by varying the volume of compressed air. This is a dramatic disadvantage in some parts of a small wastewater treatment plant, such as the aerator. [5] the suction is limited.
Regularly, for example once a month per well, the flow from one and only one selected well is led into the test separator for determining well flow rate for the selected well. [3] The separator divides the flow from the well into the streams of individual products which typically are oil, gas and water, but may include natural-gas condensate ...
When the results are collected carefully, formulas can be applied to figure the varying pressure(s) that will be available when different amounts of water flow are used from the same source. A process to perform a water flow test is explained in the model fire codes as published by NFPA (National Fire Protection Association).
The first identification letter is for the measured value, the second is a modifier, 3rd indicates passive/readout function, 4th - active/output function, and the 5th is the function modifier. This is followed by loop number, which is unique to that loop. For instance FIC045 means it is the Flow Indicating Controller in control loop 045.
where s is the drawdown (change in hydraulic head at a point since the beginning of the test in units of distance), u is a dimensionless parameter, Q is the discharge (pumping) rate of the well (volume per unit time), T and S are the transmissivity and storativity of the aquifer around the well (distance squared per unit time and dimensionless ...
FTR – function test report; FTRE – formation testing report; FULDI – full diameter study report; FV – funnel viscosity; FV – float valve; FVF – formation volume factor; FWHP – flowing well-head pressure; FWKO – free water knock-out; FWL – free water level; FWL – from West line; FWR – final well report