Ad
related to: john deere code pcu 20 pin connector kit 2
Search results
Results from the WOW.Com Content Network
The connectors are designed for 12V systems. Exceptions for the 7-pin connector may exist where they may be used for 6V and 24V. Vehicles and trailers with 6V systems can use the 7-pin or a 5-pin connector, but these are rare today. Heavy trucks that may have 12V systems are usually older (vintage vehicles) or on non-European markets. [1]
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
M12 A-coded 5-pin connector: For each connector size, the A-coding is the inspecific pinout variant and the only variant defined in varying numbers of pins. Ethernet cable with an M12 X-coded connector in one end and a modular connector in the other.
The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire (it is usually green). This connector is the largest of all the connectors. In older AT power supplies, this connector was split in two: P8 and P9. A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector.
CCS1 (Combined Charging System Combo 1) plug as used in North America. It is an extension of the J1772 standard AC charging connector. CCS Combo 1 vehicle inlet showing the J1772 and the two DC fast-charging pins Connectors: Incomplete Combo 2 (left) showing the two large direct current (DC) pins below, while the four alternating current (AC) pins for neutral and three-phase are removed, while ...
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
Ad
related to: john deere code pcu 20 pin connector kit 2