Search results
Results from the WOW.Com Content Network
Induction heating is a non contact heating process which uses the principle of electromagnetism induction to produce heat in a work-piece. In this case thermal expansion is used in a mechanical application to fit parts over one another, e.g. a bushing can be fitted over a shaft by making its inner diameter slightly smaller than the diameter of the shaft, then heating it until it fits over the ...
An induction heater is a key piece of equipment used in all forms of induction heating. Typically an induction heater operates at either medium frequency (MF) or radio frequency (RF) ranges. [1] Four main component systems form the basis of a modern induction heater
A thermic fluid heater (TFH), [1] also known as a thermal oil heater, is a device used for indirect heat transfer through a thermic fluid. It heats the fluid to a desired temperature and then transfers that heat to various processes without any direct contact between the heating source and the product.
Fluid bearings are bearings in which the load is supported by a thin layer of rapidly moving pressurized liquid or gas between the bearing surfaces. [1] Since there is no contact between the moving parts, there is no sliding friction , allowing fluid bearings to have lower friction, wear and vibration than many other types of bearings.
[1] In regenerative heat exchangers, the fluid on either side of the heat exchanger can be the same fluid. The fluid may go through an external processing step, and then it is flowed back through the heat exchanger in the opposite direction for further processing. Usually the application will use this process cyclically or repetitively.
The crankcase heater keeps refrigerant at a temperature higher than the coldest part of the system. A crankcase heater generally has the same electrical symbol as a resistor because it converts electricity directly into heat via electrical resistance. The resistance in the heater coil determines the heat it produces when voltage is applied. [1]
Induction forging refers to the use of an induction heater to pre-heat metals prior to deformation using a press or hammer. Typically metals are heated to between 1,100 and 1,200 °C (2,010 and 2,190 °F) to increase their malleability and aid flow in the forging die. [1]
The instructions advise that the heater should rest against a "rock or something" The flameless ration heater is issued in a plastic bag with instructions printed on it. Inside the bag is a small quantity of metallic powders, which does the actual heating. To heat a meal, the bag is first torn open, and a sealed food pouch is placed inside.