Ads
related to: oscilloscope volts per division
Search results
Results from the WOW.Com Content Network
The vertical section controls the amplitude of the displayed signal. This section has a volts-per-division (Volts/Div) selector knob, an AC/DC/Ground selector switch, and the vertical (primary) input for the instrument. Additionally, this section is typically equipped with the vertical beam position knob.
A dual-beam oscilloscope was a type of oscilloscope once used to compare one signal with another. There were two beams produced in a special type of CRT . Unlike an ordinary "dual-trace" oscilloscope (which time-shared a single electron beam, thus losing about 50% of each signal), a dual-beam oscilloscope simultaneously produced two separate ...
The 7A13 differential comparator ($2,865 in 1983) has a 105-MHz bandwidth. The 7A13 differential comparator amplifier can subtract a DC voltage from the input and amplify around that voltage, a feature unknown to modern digital scopes. [citation needed] Looking at voltage rails is a situation where the 7000 series still shows off. For example ...
Voltage division is the result of distributing the input voltage among the components of the divider. A simple example of a voltage divider is two resistors connected in series , with the input voltage applied across the resistor pair and the output voltage emerging from the connection between them.
The amount of bypass capacitance must be carefully matched with the input capacitance of the oscilloscope so that the capacitors also form a 10× voltage divider. In this way, the probe provides a uniform 10× attenuation from DC (with the attenuation provided by the resistors) to very high AC frequencies (with the attenuation provided by the ...
A Tektronix TDS210 digital oscilloscope. A digital storage oscilloscope (DSO) is an oscilloscope which stores and analyses the input signal digitally rather than using analog techniques. It is now the most common type of oscilloscope in use because of the advanced trigger, storage, display and measurement features which it typically provides. [1]
General purpose instrument measures voltage, current and resistance (and sometimes other quantities as well) Network analyzer: Measures network parameters Ohmmeter: Measures the resistance of a component Oscilloscope: Displays waveform of a signal, allows measurement of frequency, timing, peak excursion, offset, ... Psophometer
The time per division on the display depended upon the sweep's free-running frequency and a horizontal gain control. A synchronized sweep oscilloscope could not display a non-periodic signal because it could not synchronize the sweep generator to that signal. Horizontal circuits were often AC-coupled
Ads
related to: oscilloscope volts per division