Search results
Results from the WOW.Com Content Network
Measuring ESR can be done by applying an alternating voltage at a frequency at which the capacitor's reactance is negligible, in a voltage divider configuration. It is easy to check ESR well enough for troubleshooting by using an improvised ESR meter comprising a simple square-wave generator and oscilloscope, or a sinewave generator of a few tens of kilohertz and an AC voltmeter, using a known ...
A capacitance meter is a piece of electronic test equipment used to measure capacitance, [1] mainly of discrete capacitors. Depending on the sophistication of the meter, it may display the capacitance only, or it may also measure a number of other parameters such as leakage, equivalent series resistance (ESR), and inductance.
An LCR meter is a type of electronic test equipment used to measure the inductance (L), capacitance (C), and resistance (R) of an electronic component. [1] In the simpler versions of this instrument the impedance was measured internally and converted for display to the corresponding capacitance or inductance value. Readings should be reasonably ...
Electricity meter: Measures the amount of energy dissipated ESR meter: Measures the equivalent series resistance of capacitors Frequency counter: Measures the frequency of the current Leakage tester: Measures leakage across the plates of a capacitor LCR meter: Measures the inductance, capacitance and resistance of a component Megger tester
For example, if the meter is set to a range of 300 V full scale, the meter's impedance will be 6 MΩ. 20,000 Ω/V is the best (highest) sensitivity available for typical analog multimeters that lack internal amplifiers. For meters that do have internal amplifiers (VTVMs, FETVMs, etc.), the input impedance is fixed by the amplifier circuit.
Q-meter E9-4. Internally, a minimal Q meter consists of a tuneable RF generator with a very low (pass) impedance output and a detector with a very high impedance input. There is usually provision to add a calibrated amount of high Q capacitance across the component under test to allow inductors to be measured in isolation.
LCR meter - inductance (L), capacitance (C) and resistance (R) meter (measure LCR values) The following are used for stimulus of the circuit under test: Power supplies; Signal generator; Digital pattern generator; Pulse generator; Voltcraft M-3850 portable multimeter. The following analyze the response of the circuit under test:
Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .