Search results
Results from the WOW.Com Content Network
This is the case on many large aircraft such as the 747, C-17, KC-10, etc. If you are on an aircraft and you hear the engines increasing in power after landing, it is usually because the thrust reversers are deployed. The engines are not actually spinning in reverse, as the term may lead you to believe.
An aircraft engine, often referred to as an aero engine, is the power component of an aircraft propulsion system. Aircraft using power components are referred to as powered flight. [1] Most aircraft engines are either piston engines or gas turbines, although a few have been rocket powered and in recent years many small UAVs have used electric ...
If aircraft performance were to increase beyond such a barrier, a different propulsion mechanism was necessary. This was the motivation behind the development of the gas turbine engine, the most common form of jet engine. The key to a practical jet engine was the gas turbine, extracting power from the engine itself to drive the compressor.
The thrust force from a stationary engine becomes thrust power when an aircraft is moving under its influence. Zhemchuzhin et al. [27] show an energy balance for a turbojet engine in flight in the form of a Sankey diagram. Component losses leave the engine as waste heat and add to the heat rejected area on a T~s diagram reducing the work area ...
The rate at which parts deteriorate in a gas turbine is unbalanced insofar as the hottest parts need replacing or repairing more often than the cooler-running parts. If the hotter parts can be removed without disturbing the rest of the engine, for example without removing the complete engine from the aircraft, maintenance costs are reduced.
Aircraft engines may have a spline upon which mounts the propeller. There may be a master spline which is wider than the others, so that the propeller may go on at only one orientation, to maintain dynamic balance. This arrangement is commonly found in larger engines, whereas smaller engines typically use a pattern of threaded fasteners instead.
In 1940, after receiving a request in March of that year from the Ministry of Aircraft Production for a high-rated (40,000 ft (12,000 m)) Merlin for use as an alternative engine to the turbocharged Hercules VIII used in the prototype high-altitude Vickers Wellington V bomber, Rolls-Royce started experiments on the design of a two-stage ...
The first production P-59A with a Bell P-63 Kingcobra behind. The 13 service test YP-59As had a more powerful engine than their predecessor, the General Electric J31, but the performance improvement was negligible, with top speed increased by only 5 mph and a reduction in the time they could be used before an overhaul was needed.