Search results
Results from the WOW.Com Content Network
Oakum and tools for caulking Hemp Prisoners picking oakum at Coldbath Fields Prison in London. Oakum is a preparation of tarred fibers used to seal gaps. Its traditional application was in shipbuilding for caulking or packing the joints of timbers in wooden vessels and the deck planking of iron and steel ships. [1]
The bilge water that collects here include drain water or leftover water from the boilers, water collecting tanks, drinking water and other places where water can not overflow. However, bilge water doesn't just include water drainage. Another system that drains into the Bilge system comes from the propulsion area of the ship.
Copper sheathing is a method for protecting the hull of a wooden vessel from attack by shipworm, barnacles and other marine growth through the use of copper plates affixed to the surface of the hull, below the waterline. It was pioneered and developed by the Royal Navy during the 18th century. In antiquity, ancient Chinese used copper plates ...
The reason for this is that when the boat is level, the drain or other opening will always be above the waterline, and so water will only flow out. At sea, when the boat rolls in the waves, the opening may sometimes be below the waterline. If the seacock is open, water may flood the boat, causing it to sink. Sea valve at lower right
Trap with copper drain pipe at underside of firestop packing in two-hour fire-resistance rated concrete floor slab Typical P-trap. Maintaining the water seal is critical to trap operation; traps might dry out, and poor venting can suction or blow water out of the traps. This is usually avoided by venting the drain pipes downstream of the trap ...
Marine grade stainless alloys typically contain molybdenum to resist the corrosive effects of NaCl or salt in seawater. Concentrations of salt in seawater can vary, and splash zones can cause concentrations to increase dramatically from the spray and evaporation.
A French drain, PVC pipe, or other drainage system is installed in the newly made channel. The installed drain is covered with new cement. The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement.
A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge. Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors.