Search results
Results from the WOW.Com Content Network
IPv6 hosts are required to support multiple addresses per interface; moreover, every IPv6 host is required to configure a link-local address even when global addresses are available. IPv6 hosts may additionally self-configure additional addresses on receipt of router advertisement messages, thus eliminating the need for a DHCP server.
The Neighbor Discovery Protocol (NDP), or simply Neighbor Discovery (ND), is a protocol of the Internet protocol suite used with Internet Protocol Version 6 (IPv6). [1]: §1 It operates at the internet layer of the Internet model, [2] and is responsible for gathering various information required for network communication, including the configuration of local connections and the domain name ...
On an iPhone/iPad: Settings > WiFi > tap the arrow next to your network name > your IP address is displayed to the right of “IP address.” You Might Also Like The Do’s and Don’ts of Using ...
The design of the IPv6 address space implements a different design philosophy than in IPv4, in which subnetting was used to improve the efficiency of utilization of the small address space. In IPv6, the address space is deemed large enough for the foreseeable future, and a local area subnet always uses 64 bits for the host portion of the ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [ 2 ] (routable only within the scope of private networks, but not the global IPv6 Internet).
A solicited-node multicast address is an IPv6 multicast address used by the Neighbor Discovery Protocol to determine the link layer address associated with a given IPv6 address, which is also used to check if an address is already being used by the local-link or not, through a process called DAD (Duplicate Address Detection). The solicited-node ...
According to RFC 3964, 6to4 routers and relays should ensure that: either or both the source and destination addresses of any encapsulated packet is within the 6to4 IPv6 prefix 2002:: / 16, if the source IPv6 address is a 6to4 IPv6 address, its corresponding 6to4 router IPv4 address matches the IPv4 source address in the IPv4 encapsulation header,