Search results
Results from the WOW.Com Content Network
Starting fluid is sprayed into the engine intake near the air filter, or into the carburetor bore or a spark plug hole of an engine to get added fuel to the combustion cylinder quickly. Using starting fluid to get the engine running faster avoids wear to starters and fatigue to one's arm with pull start engines, especially on rarely used machines.
The largest part of most combustion gas is nitrogen (N 2), water vapor (H 2 O) (except with pure-carbon fuels), and carbon dioxide (CO 2) (except for fuels without carbon); these are not toxic or noxious (although water vapor and carbon dioxide are greenhouse gases that contribute to climate change).
The enthalpy of combustion of propane gas where products do not return to standard state, for example where the hot gases including water vapor exit a chimney, (known as lower heating value) is −2043.455 kJ/mol. [29] The lower heat value is the amount of heat available from burning the substance where the combustion products are vented to the ...
Carbon build-up in the intake manifold will occur when blow-by gases are allowed to permanently contaminate the intake air because of a failing PCV system. [12] Carbon build-up or oil sludge from blow-by gases on intake valves are usually not a problem in port injected engines. This is due to the fact that the fuel hits the intake valves on the ...
At idle speeds on a new engine poor machining tolerances could prevent the lifter from spinning and destroy the camshaft. After 20 minutes of wear, or "self machining" at higher engine speeds they would typically be able to spin freely. In the past, the engine break-in period was very important to the overall life and durability of the engine.
A cold start is an attempt to start a vehicle's engine when ambient temperatures are much lower than its normal operating temperature. [1] A cold start can be difficult for an engine due to higher viscosity of oil and fuel in cold temperatures.
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
These engines can either be full-time lean-burn, where the engine runs with a weak air–fuel mixture regardless of load and engine speed, or part-time lean-burn (also known as "lean mix" or "mixed lean"), where the engine runs lean only during low load and at high engine speeds, reverting to a stoichiometric air–fuel mixture in other cases.