Search results
Results from the WOW.Com Content Network
The glass used typically starts out as 1-inch-wide (25 mm) strips of 1 ⁄ 4-inch-thick (6.4 mm) plate glass, which is cut into 1 inch (2.5 cm) squares. The glass square is then scored across the diagonal with a steel or tungsten carbide glass-cutting wheel to determine where the square will break, and pressure is then applied gradually across ...
Fenton had a long history of decorating glass that goes back to its beginnings in 1905. [1] The Fenton Art Glass company started out as a decorating company that purchased blanks from glass manufacturers and placed their own decorations on them. [2] Fenton did not manufacturer glass until 1907 a year after the Williamstown, WV plant was built. [2]
The cut cylinder is then placed in an oven where the cylinder unrolls into a flat glass sheet. Blenko Glass Company used this method to make flat glass during the 20th century, but it used a process patented by William Blenko that used molds for the cylinder to enable consistency in the size of the glass. In Blenko's case, slight imperfections ...
The Nickel Plate Glass Company was formed in West Virginia in early 1888 by a group of glass men from Wheeling, West Virginia, and points nearby.The major shareholders were Peter Cassell, August Rolf, Andy J. Smith, Benjamin Hildreth, W. H. Robinson, and James B. Russell. [11]
Plate glass is often used in windows. Fragment of a Roman window glass plate dated to 1st to 4th century CE. Plate glass, flat glass or sheet glass is a type of glass, initially produced in plane form, commonly used for windows, glass doors, transparent walls, and windscreens. For modern architectural and automotive applications, the flat glass ...
The Westmoreland Glass Company was founded in 1889 when a group of men purchased the Specialty Glass Company located in East Liverpool, Ohio, and moved it to Grapeville, Pennsylvania. [1] Grapeville was chosen as the location of the factory because the property had a large source of natural gas. George West served as president of the company ...
The greater the hone angle of the wheel, the sharper the angle of the V and the thicker the piece of glass it is designed to cut. The hone angle on most hand-held glass cutters is 120° to 140°, though wheels are made as near-flat as 154° or even 160° [180° would be flat like a roller] for cutting glass as thick as 0.5 inches (13 mm). [4]
Safelite Group, Inc. is an American provider of automotive glass repair and replacement services, wholesale automotive glass sales, along with insurance claims management, based in Columbus, Ohio. Safelite is being sued by the state of California and faces a September 2025 trial for alleged insurance fraud.