Search results
Results from the WOW.Com Content Network
The US data is collected and compiled into an annual evaporation map. [4] The measurements range from under 30 to over 120 inches per year. Formulas can be used for calculating the rate of evaporation from a water surface such as a swimming pool. [5] [6] In some countries, the evaporation rate far exceeds the precipitation rate.
The wet-bulb temperature is the lowest temperature that may be achieved by evaporative cooling of a water-wetted, ventilated surface.. By contrast, the dew point is the temperature to which the ambient air must be cooled to reach 100% relative humidity assuming there is no further evaporation into the air; it is the temperature where condensation (dew) and clouds would form.
Salt water chlorination is a process that uses dissolved salt (1000–4000 ppm or 1–4 g/L) for the chlorination of swimming pools and hot tubs.The chlorine generator (also known as salt cell, salt generator, salt chlorinator, or SWG) uses electrolysis in the presence of dissolved salt to produce chlorine gas or its dissolved forms, hypochlorous acid and sodium hypochlorite, which are already ...
The Penman equation describes evaporation (E) from an open water surface, and was developed by Howard Penman in 1948. Penman's equation requires daily mean temperature, wind speed, air pressure, and solar radiation to predict E. Simpler Hydrometeorological equations continue to be used where obtaining such data is impractical, to give comparable results within specific contexts, e.g. humid vs ...
The most important physical parameter describing a pool fire is the heat release rate, which determines the minimum safe distance needed to avoid burns from thermal radiation. The heat release rate is limited by the rate of evaporation of the fuel, as the combustion reaction takes place in the gas phase.
A swimming pool, swimming bath, wading pool, paddling pool, or simply pool, is a structure designed to hold water to enable swimming and associated activities. Pools can be built into the ground (in-ground pools) or built above ground (as a freestanding construction or as part of a building or other larger structure), and may be found as a ...
2) Determine total evaporation required, and estimate steam consumption for the number of effects chosen. 3) Calculate evaporation in the first effect from assumed feed temperature or flowrate. Repeat for following effects, and check that initial and intermediate assumptions are still valid.
Evaporation systems are also often evaluated by the water evaporation rate per unit area. When the energy is largely provided by sunlight, these are often evaluated with a solar efficiency, (), which is a thermal efficiency that compares incoming light energy to the enthalpy of vaporization. This is the same as the gained output ratio (GOR) in ...