Ads
related to: aluminum square tubing with flange sizes 10 to 18 feet length and width- All Metals Cut to Size
Custom Cut, Packed & Shipped.
Precise Tolerances on All Material.
- No Minimum Orders
Always No Minimum Order Size.
Materials From Under $1.
- OnlineMetals.com
Aluminum, Stainless, Copper, Brass.
No Minimum Orders! Fast Shipping.
- Full Metals Selection
Aluminum, Brass, Copper, Cold Roll.
Hot Roll, Nickel, Titanium & More.
- All Metals Cut to Size
Search results
Results from the WOW.Com Content Network
During the manufacturing process the mother tube goes through a series of shaping stands which form the round HSS (mother tube) into the final square or rectangular shape. Most American manufacturers adhere to the ASTM A500 or newly adopted ASTM A1085 standards, while Canadian manufacturers follow both ASTM A500 and CSA G40.21.
When tubes are used for these purposes they may be 10'-6" to 12 foot diameter, and up to 250 foot long, using up to 1/2" plate and ovaling ring stiffeners at 8 foot (to 20 foot centers). On one such project My firm added L8x8x3/4 at the top 45 degree location to stiffen the plate near the point of maximum stress for tubes (as per Timoshenko ...
For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.
T-slot framing is divided into metric and fractional (imperial) categories. The T-slot is always centered along the long-axis of the piece. Pieces are available in each series with a square cross-section. Rectangular cross sections are also available which measure x by 2x (where x is the defined width) - e.g. 40mm by 80mm for 40 series.
For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m). Wide flange section beams often vary from their nominal depth. In the case of the W14 series, they may be as deep as 22.84 in (580 mm).
EN10219-1 specifies the technical delivery conditions for cold formed welded structural hollow sections of circular, square or rectangular forms and applies to structural hollow sections formed cold without subsequent heat treatment. Requirements for S275JOH pipe tolerances, dimensions and sectional s275 pipe properties are contained in EN 10219-2.
Ads
related to: aluminum square tubing with flange sizes 10 to 18 feet length and width