Ad
related to: triac light dimmer circuit
Search results
Results from the WOW.Com Content Network
TRIAC. For other uses, see Triac. A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor[ 1 ]) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericised trademark. TRIACs are a subset of thyristors (analogous to a relay ...
A silicon controlled rectifier or semiconductor controlled rectifier is a four-layer solid-state current -controlling device. The name "silicon controlled rectifier" is General Electric 's trade name for a type of thyristor. The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell ...
References. 0-10 V lighting control. 0–10 V is one of the first and simplest electronic lighting control signaling systems, used as an early fluorescent dimming system. [ 1 ] Simply put, the control signal is a DC voltage that varies between zero and ten volts. Two standards are recognized: current sourcing and current sinking.
The thyristor is a four-layered, three-terminal semiconductor device, with each layer consisting of alternating N-type or P-type material, for example P-N-P-N. The main terminals, labelled anode and cathode, are across all four layers. The control terminal, called the gate, is attached to p-type material near the cathode.
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...
Adjusting the brightness of light emitted by a light source is then merely a matter of setting at what voltage (or phase) in the AC half-cycle the dimmer begins to provide electric current to the light source (e.g. by using an electronic switch such as a triac). In this case the PWM duty cycle is the ratio of the conduction time to the duration ...
Potentiometer. A potentiometer is a three- terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. [1] If only two terminals are used, one end and the wiper, it acts as a variable resistor or rheostat. The measuring instrument called a potentiometer is essentially a voltage divider used for measuring ...
Zero-crossing control (or burst-fire control) is an approach for electrical control circuits that starts operation with the AC load voltage at close to 0 volts in the AC cycle. [ 1 ] This is in relation to solid-state relays, such as TRIACs and silicon controlled rectifiers. [ 1 ] The purpose of the circuit is to start the TRIAC conducting very ...
Ad
related to: triac light dimmer circuit