Search results
Results from the WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The OEM Limited slip differential originally was a "Power Lok" until 1998 when the "Trac Lok" phased it out. Trac Loks were a US$350.00 option with Ford Super Duty trucks. [ 1 ] The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions.
Eaton manufactures the differential and Dana manufactures the rest of the axle. The S110 model follows a newer nomenclature for Dana axles. The "S" meaning: single rear axle. The first "1" representing gear reduction type, the second representing the head assembly series and the last "0" representing the design level.
[[Category:General Motors templates]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:General Motors templates]]</noinclude> to the end of the template code, making sure it starts on the same line as the code's last character.
This is a list of auto parts, which are manufactured components of automobiles.This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive.