enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Power-on self-test - Wikipedia

    en.wikipedia.org/wiki/Power-on_self-test

    Power supply may be bad Long continuous beep tone Memory failure Steady, long beeps Power supply bad No beep Power supply bad, system not plugged in, or power not turned on No beep If everything seems to be functioning correctly there may be a problem with the 'beeper' itself. The system will normally beep one short beep. One long, two short beeps

  3. Power good signal - Wikipedia

    en.wikipedia.org/wiki/Power_good_signal

    The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.

  4. POST card - Wikipedia

    en.wikipedia.org/wiki/POST_card

    A typical card for desktop computers has a different bus interface on each edge; a card for laptop computers may have both a miniPCI and a parallel port connector (plus USB to supply power). Modern motherboards often do not broadcast POST codes to their PCI Express slots (PCIe switches only pass on transactions after having been configured to ...

  5. ATX - Wikipedia

    en.wikipedia.org/wiki/ATX

    PS_ON# (power on) is a signal from the motherboard to the power supply. When the line is connected to ground (by the motherboard), the power supply turns on. It is internally pulled up to +5 V inside the power supply. [3] [19] PWR_OK ("power good") is an output from the power supply that indicates that its output has stabilized and is ready for ...

  6. Built-in self-test - Wikipedia

    en.wikipedia.org/wiki/Built-in_self-test

    Unattended machinery performs self-tests to discover whether it needs maintenance or repair. Typical tests are for temperature, humidity, bad communications, burglars, or a bad power supply. For example, power systems or batteries are often under stress, and can easily overheat or fail. So, they are often tested.

  7. PS-ON Signal - Wikipedia

    en.wikipedia.org/wiki/PS-ON_Signal

    #PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).

  8. Fix problems reading or receiving AOL Mail

    help.aol.com/articles/fix-problems-reading-or...

    If possible, ask the sender to resend the message to see if you can get the message a second time. Check for emails in your Spam folder. If you find emails in your Spam folder that don't belong there, you'll need to mark the messages as "not spam." 1. Sign in to AOL Mail. 2. Click the Spam folder. 3. Select the message that isn't spam. 4.

  9. Power supply unit (computer) - Wikipedia

    en.wikipedia.org/wiki/Power_supply_unit_(computer)

    The desktop computer power supply converts the alternating current (AC) from a wall socket of mains electricity to a low-voltage direct current (DC) to operate the motherboard, processor and peripheral devices. Several direct-current voltages are required, and they must be regulated with some accuracy to provide stable operation of the computer.