enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Buck–boost transformer - Wikipedia

   en.wikipedia.org/wiki/Buck–boost_transformer

   Buck–boost transformers can be used to power low voltage circuits including control, lighting circuits, or applications that require 12, 16, 24, 32 or 48 volts, consistent with the design's secondaries. The transformer is connected as an isolating transformer and the nameplate kVA rating is the transformer’s capacity. [2]

3. Distribution transformer - Wikipedia

   en.wikipedia.org/wiki/Distribution_transformer

   A "transformer bank", widely used in North America: three single-phase transformers connected to make a 3-phase transformer. The low-voltage secondary windings are attached to three or four terminals on the transformer's side. In North American residences and small businesses, the secondary is often the split-phase 120/240-volt system. The 240 ...

4. Per-unit system - Wikipedia

   en.wikipedia.org/wiki/Per-unit_system

   By choosing the base quantities in this manner, the transformer can be effectively removed from the circuit as described above. For example: Take a transformer that is rated at 10 kVA and 240/100 V. The secondary side has an impedance equal to 1∠0° Ω. The base impedance on the secondary side is equal to:

5. High-leg delta - Wikipedia

   en.wikipedia.org/wiki/High-leg_delta

   Center-tapped delta transformer Center-tapped delta transformer voltages. High-leg delta service is supplied in one of two ways. One is by a three-phase transformer (or three single-phase transformers), having four wires coming out of the secondary, the three phases, plus a neutral connected as a center-tap on one of the windings.

6. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   A transformer supplying a three-wire distribution system has a single-phase input (primary) winding. The output (secondary) winding has a center tap connected to a grounded neutral. As shown in Fig. 1, either end to center has half the voltage of end-to-end. Fig. 2 illustrates the phasor diagram

7. Transformer types - Wikipedia

   en.wikipedia.org/wiki/Transformer_types

   A planar transformer Exploded view: the spiral primary "winding" on one side of the PCB (the spiral secondary "winding" is on the other side of the PCB) Manufacturers either use flat copper sheets or etch spiral patterns on a printed circuit board to form the "windings" of a planar transformer, replacing the turns of wire used to make other ...