Search results
Results from the WOW.Com Content Network
In a digitally modulated signal or a line code, symbol rate, modulation rate or baud rate is the number of symbol changes, waveform changes, or signaling events across the transmission medium per unit of time. The symbol rate is measured in baud (Bd) or symbols per second. In the case of a line code, the symbol rate is the pulse rate in pulses ...
As the description implies, is the signal energy associated with each user data bit; it is equal to the signal power divided by the user bit rate (not the channel symbol rate). If signal power is in watts and bit rate is in bits per second, E b {\displaystyle E_{b}} is in units of joules (watt-seconds).
In a noisy channel, the BER is often expressed as a function of the normalized carrier-to-noise ratio measure denoted Eb/N0, (energy per bit to noise power spectral density ratio), or Es/N0 (energy per modulation symbol to noise spectral density).
It leads to a maximal rate of information of 10 6 log 2 (1 + 10 −3) = 1443 bit/s. These values are typical of the received ranging signals of the GPS, where the navigation message is sent at 50 bit/s (below the channel capacity for the given S/N), and whose bandwidth is spread to around 1 MHz by a pseudo-noise multiplication before transmission.
When UI is used as a measurement unit of a time interval, the resulting measure of such time interval is dimensionless. It expresses the time interval in terms of UI. Very often, but not always, the UI coincides with the bit time, i.e. with the time interval taken to transmit one bit (binary information digit).
So each sample encodes one of a finite number of "symbols", which in turn represent one or more binary digits (bits) of information. Each symbol is encoded as a different combination of amplitude and phase of the carrier, so each symbol is represented by a point on the constellation diagram, called a constellation point. The constellation ...
A commonly used code encodes = eight-bit data symbols plus 32 eight-bit parity symbols in an =-symbol block; this is denoted as a (,) = (,) code, and is capable of correcting up to 16 symbol errors per block.
The bit time has nothing to do with the time it takes for a bit to travel on the network medium but has to do with the internals of the NIC. To calculate the bit time at which a NIC ejects bits, use the following: bit time = 1 / NIC speed To calculate the bit time for a 10 Mbit/s NIC, use the formula as follows: