Search results
Results from the WOW.Com Content Network
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
The top and bottom plates are end-nailed to each stud with two nails at least 3 + 1 ⁄ 4 in (83 mm) in length (16d or 16-penny nails). Studs are at least doubled (creating posts) at openings, the jack stud being cut to receive the lintels (headers) that are placed and end-nailed through the outer studs. [10] Moisture barrier sheathing with ...
Story – A post only one story tall as in "storeyed construction" [12] also known as platform framing. Prick – 1) Same as story post, a one-story post for extra support at a particular location; 2) In a roof truss a side post. [13] Ridge – A post extending from the ground or foundation to the ridge beam.
Other girt systems include framing in between the posts rather than on the outer side of the posts. [6] Siding materials for a pole building are most commonly rolled-rib 29-gauge enameled steel cut to length in 32-or-36-inch (813 or 914 mm) widths attached using color-matched screws with rubber washers to seal the holes.
Jack posts are telescopic tubular steel props consisting of two primary parts, the main part of the post, and the jack screw or other adjustable fitting on one or both ends. Both ends are normally fitted with flat metal plates on the end, providing additional support area.
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
Steel failure: the weak part of the connection is represented by the rod. The failure corresponds to the tensile break-out of steel as in case of tensile testing. In this case, concrete base material might be undamaged. Pull-out: the anchor is pulled out from the drilled hole partially damaging the surrounding concrete.
These are barriers between exterior metal and interior metal, usually made of polyvinyl chloride (PVC). These breaks provide a significant decrease in the thermal conductivity of the curtain wall. However, since the thermal break interrupts the aluminum mullion, the overall moment of inertia of the mullion is reduced and must be accounted for ...