Search results
Results from the WOW.Com Content Network
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
Cutaway of a dual overhead camshaft engine 1969 AMC V8 overhead valve engine. The rocker cover has been removed, so the pushrods, rocker arms, valve springs, and valves are visible. A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1]
A desmodromic valve is a reciprocating engine poppet valve that is positively closed by a cam and leverage system, rather than by a more conventional spring. The valves in a typical four-stroke engine allow the air/fuel mixture into the cylinder at the beginning of the cycle and exhaust spent gases at the end of the cycle.
The engine configuration describes the fundamental operating principles by which internal combustion engines are categorized.. Piston engines are often categorized by their cylinder layout, valves and camshafts.
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
The most common use of a rocker arm is to transfer the motion of a pushrod in an overhead valve (OHV) internal combustion engine to the corresponding intake/exhaust valve. In an OHV engine the camshaft at the bottom of the engine pushes the pushrod upwards. The top of the pushrod presses upwards on one side of the rocker arm located at the top ...
In an overhead valve engine the tappets (on right) are sandwiched between pushrods and the camshaft. In an internal combustion engine, a tappet (also called a 'valve lifter' or 'cam follower') [3] [4] [5] is the component which converts the rotation of the camshaft into vertical motion to open and close an intake or exhaust valve.
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.