enow.com Web Search

  1. Ads

    related to: bathroom faucet leaking from inside house with hose hole in bottom

Search results

  1. Results from the WOW.Com Content Network
  2. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...

  3. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    The most common plumbing fixtures are: Bathtubs; Bidets; Channel drains; Drinking fountains; Showers; Sinks; Tap (connections for water hoses) . Tapware - an industry term for that sub-category of plumbing fixtures consisting of tap valves, also called water taps (British English) or faucets (American English), and their accessories, such as water spouts and shower heads.

  4. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US). Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    This view looking upwards through a hole in the ceiling shows a traditional leaded hub joint (at top) and a more recent rubber-sleeved hubless connection (at lower right). Because they operate at low pressure and rely on gravity to move fluids (and entrained solids), drain-waste-vent systems use fittings whose interior surfaces are as smooth as ...

  6. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

  7. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    The pipes were hollowed-out logs which were tapered at the end with a small hole in which the water would pass through. [23] The multiple pipes were then sealed together with hot animal fat. Wooden pipes were used in Philadelphia, [24] Boston, and Montreal in the 1800s. Built-up wooden tubes were widely used in the US during the 20th century.

  1. Ads

    related to: bathroom faucet leaking from inside house with hose hole in bottom