Search results
Results from the WOW.Com Content Network
Two-letter signals for other messages, sometimes followed with a numerical "complement" which supplements or modifies the message. Three-letter signals beginning with "M"; these are the Medical Signal Codes. In some cases, additional characters are added to indicate quantities, bearing, course, distance, date, time, latitude, or longitude.
2-digit number: The diameter of the tire in inches. x: Separator character. 3- or 4-digit number: The section width (cross-section) of the tire in inches. If the tire diameter is not given, section widths ending in zero (e.g., 7.00 or 10.50) indicate the aspect ratio of 92%, while section widths not ending in zero (e.g., 7.05 or 10.55) indicate ...
Letter flags and ICS meanings Letter / radio name Flag Blazon ICS meaning as single flag Meaning when used with numeric complements A Alfa: Swallowtailed, per pale argent and azure "I have a diver down; keep well clear at slow speed." Azimuth or bearing B Bravo: Swallowtailed, gules "I am taking in or discharging or carrying dangerous goods."
The code typically reflects the name or identifying number of the owner, lessee, or operator of the equipment, similar to IATA airline designators. In North America, the mark, which consists of an alphabetic code of two to four letters, is stenciled on each piece of equipment, along with a one- to six-digit number. This information is used to ...
The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. R17A, R17B. The IEEE 315 standard contains a list of Class Designation Letters to use for electrical and electronic ...
The bearing is expressed in terms of 2 characters and 1 number: first, the character is either N or S; next is the angle numerical value; third, the character representing the perpendicular direction, either E or W. The bearing angle value will always be less than 90 degrees. [1]
A part number (often abbreviated PN, P/N, part no., or part #) is an identifier of a particular part design or material used in a particular industry. Its purpose is to simplify reference that item. A part number unambiguously identifies a part design within a single corporation, sometimes across several corporations. [1]
The complete nomenclature consists of an Approved Item Name (AIN), an extended modifier (if applicable), and the type designation. The AIN is presented in all capital letters, is not abbreviated, and is followed by a colon. Each AIN has a corresponding 6-digit Item Name Code (INC) which can be referenced in the H6 Cataloging Handbook.