enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Category 6 cable - Wikipedia

   en.wikipedia.org/wiki/Category_6_cable

   A Cat 6 patch cable, terminated with 8P8C modular connectors. Category 6 cable (Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and ...

3. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   Most wired Ethernet communications are carried over Category 5e or Category 6 cable terminated with 8P8C modular plugs. The connector is also used in other telecommunications connections, including ISDN and T1. Where building network and telephone wiring is pre-installed, the center (blue) pair is often used to carry telephony signals. While ...

4. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

5. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   The standard specifies how to connect eight-conductor 100-ohm balanced twisted-pair cabling, such as Category 5 cable, to 8P8C modular connectors (often referred to as RJ45 connectors). The standard defines two alternative pinouts: T568A and T568B. ANSI/TIA-568 recommends the T568A pinout for horizontal cables.

6. EtherCON - Wikipedia

   en.wikipedia.org/wiki/EtherCON

   The chassis connector is always female and has the standard form factor of an XLR panel connector. The chassis connector may be mated with an EtherCON connector and a standard 8P8C plug. The chassis connectors are rated for either Cat 5e, Cat 6 or 6A compatibility, with the Cat 5e and 6A models being cross-compatible. (The Cat 6 model utilizes ...

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...