enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dana 44 - Wikipedia

   en.wikipedia.org/wiki/Dana_44

   On some differentials only the high speed 2.72–3.73 carrier is used for all gear sets up to 5.89 (JK, Nissan or when thick gears are used) Axle shaft diameter 1.175" front outer (19 spline) 1.20" rear (10 spline) 1.30" rear (19 spline) 1.31" front inner (30 spline) 1.31" rear (30 spline) 1.41" rear (32 spline)

3. Gear oil - Wikipedia

   en.wikipedia.org/wiki/Gear_oil

   Gear oil being added to the final reduction gears in a scooter. EP additives which contain phosphorus/sulfur compounds are corrosive to yellow metals such as the copper and/or brass used in bushings and synchronizers, unless properly buffered; the GL-1 class of gear oils does not contain any EP additives and thus used to be the choice in ...

4. GM 10.5-inch 14-bolt differential - Wikipedia

   en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

   While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found ...

5. Jaguar independent rear suspension - Wikipedia

   en.wikipedia.org/wiki/Jaguar_independent_rear...

   The universal joints act as inner and outer pivots for the top link, which rotates to transmit drive from its inner pivot at the output of the differential/brake unit to its outer pivot at the wheel carrier. The wheel carrier takes the form of a splined stub axle (for knock-off wheels) or a stub axle and hub plate (for 5-lug wheels). In later ...

6. Dana 70 - Wikipedia

   en.wikipedia.org/wiki/Dana_70

   The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.

7. Dana 60 - Wikipedia

   en.wikipedia.org/wiki/Dana_60

   Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...