enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ring size - Wikipedia

   en.wikipedia.org/wiki/Ring_size

   Ring size is a measurement ... in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals ... 12 + 1 ⁄ 4: Y: 28: 27.8 0.858 ...

3. French catheter scale - Wikipedia

   en.wikipedia.org/wiki/French_catheter_scale

   The French size is a measure of the outer diameter of a catheter (not internal drainage channel, or inner diameter). So, for example, if a two-way catheter of 20 Fr is compared to a 20 Fr three-way catheter, they both have the same external diameter but the two-way catheter will have a larger drainage channel than the three-way.

4. List of scale model sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_scale_model_sizes

   A few rockets and some fit-in-the-box aircraft are made to this size. 1:120: 0.1 in: 2.54 mm: Model railways (TT) Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm

5. Scale length (string instruments) - Wikipedia

   en.wikipedia.org/wiki/Scale_length_(string...

   (A full-size instrument is described as 4/4.) Cellos exist in a smaller range of sizes than violins, with 4/4, 3/4, 1/2, 1/4, 1/8, and 1/10 being reasonably common. As with the violin, the Stradivarius scale is regarded as standard for orchestral work; This is about 27.4 inches (700 mm).

6. Scale ruler - Wikipedia

   en.wikipedia.org/wiki/Scale_ruler

   A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.

7. Gauge (firearms) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(firearms)

   However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge shells with their lower pressure rating of 11,500 psi (79 MPa), began to approach the performance of the 3 + 1 ⁄ 2-inch (89 mm) 10-gauge shells with a ...

8. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...

9. Traditional point-size names - Wikipedia

   en.wikipedia.org/wiki/Traditional_point-size_names

   (11) Diamond (4.5 pt, 1.5875 mm). Fonts originally consisted of a set of moveable type letterpunches purchased from a type foundry . As early as 1600, the sizes of these types—their "bodies" [ 1 ] —acquired traditional names in English, French, German, and Dutch, usually from their principal early uses. [ 2 ]