Search results
Results from the WOW.Com Content Network
Modifies stack for entry to procedure for high level language. Takes two operands: the amount of storage to be allocated on the stack and the nesting level of the procedure. INSB/INSW: 6C Input from port to string. May be used with a REP prefix to repeat the instruction CX times. equivalent to:
In computer programming, assembly language (alternatively assembler language [1] or symbolic machine code), [2] [3] [4] often referred to simply as assembly and commonly abbreviated as ASM or asm, is any low-level programming language with a very strong correspondence between the instructions in the language and the architecture's machine code instructions. [5]
x86 assembly language includes instructions for a stack-based floating-point unit (FPU). The FPU was an optional separate coprocessor for the 8086 through the 80386, it was an on-chip option for the 80486 series, and it is a standard feature in every Intel x86 CPU since the 80486, starting with the Pentium.
As it is an assembly language, BAL uses the native instruction set of the IBM mainframe architecture on which it runs, System/360.. The successors to BAL use the native instruction sets of the IBM mainframe architectures on which they run, including System/360, System/370, System/370-XA, ESA/370, ESA/390, and z/Architecture.
This is a list of the instructions in the instruction set of the Common Intermediate Language bytecode. Opcode abbreviated from operation code is the portion of a machine language instruction that specifies the operation to be performed. Base instructions form a Turing-complete instruction set.
Machine code is a strictly numerical language, and it is the lowest-level interface to the CPU intended for a programmer. Assembly language provides a direct map between the numerical machine code and a human-readable mnemonic. In assembly, numerical opcodes and operands are replaced with mnemonics
In the x86 assembly language, the JMP instruction performs an unconditional jump. Such an instruction transfers the flow of execution by changing the program counter.There are a number of different opcodes that perform a jump; depending on whether the processor is in real mode or protected mode, and an override instruction is used, the instructions may take 16-bit, 32-bit, or segment:offset ...
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).