Search results
Results from the WOW.Com Content Network
A network switch is a multiport network bridge that uses MAC addresses to forward data at the data link layer (layer 2) of the OSI model. Some switches can also forward data at the network layer (layer 3) by additionally incorporating routing functionality. Such switches are commonly known as layer-3 switches or multilayer switches. [2]
For example, the sample diagram does not indicate the physical type of connection between the PCs and the switch, but since a modern LAN is depicted, Ethernet may be assumed. If the same style of line was used in a WAN (wide area network) diagram, however, it may indicate a different type of connection.
Example scenario: a switch with VLAN 100, converted into a Private VLAN with one P-Port, two I-Ports in Isolated VLAN 101 (Secondary) and two community VLANs 102 and 103 (Secondary), with 2 ports in each. The switch has one uplink port (trunk), connected to another switch. The diagram shows this configuration graphically.
Switches typically have no built-in method to indicate VLAN to port associations to someone working in a wiring closet. It is necessary for a technician to either have administrative access to the device to view its configuration, or for VLAN port assignment charts or diagrams to be kept next to the switches in each wiring closet.
In general, the more interconnections there are, the more robust the network is; but the more expensive it is to install. Therefore, most network diagrams are arranged by their network topology which is the map of logical interconnections of network hosts. Common topologies are: Bus network: all nodes are connected to a common medium along this ...
On Cisco Devices, VTP (VLAN Trunking Protocol) maintains VLAN configuration consistency across a single Layer 2 network. VTP uses Layer 2 frames to manage the addition, deletion, and renaming of VLANs from switches in the VTP client mode. VTP is responsible for synchronizing VLAN information within a VTP domain and reduces the need to configure ...
The switch with the lowest priority of all the switches will be the root; if there is a tie, then the switch with the lowest priority and lowest MAC address will be the root. For example, if switches A (MAC = 0200.0000.1111 ) and B (MAC = 0200.0000.2222 ) both have a priority of 32,768 then switch A will be selected as the root bridge.
The inside of a Cisco 1900-series switch. Catalyst is the brand for a variety of network switches, wireless controllers, and wireless access points sold by Cisco Systems.While commonly associated with Ethernet switches, a number of different types of network interfaces have been available throughout the history of the brand.