Search results
Results from the WOW.Com Content Network
1:32 scale is a traditional scale for models and miniatures, in which one unit (such as an inch or a centimeter) on the model represents 32 units on the actual object. It is also known as "three-eighths scale", since 3 ⁄ 8 inch represents a foot. A 6 ft (183 cm) tall person is modeled as 2 + 1 ⁄ 4 in (57 mm) tall in 1:32 scale.
Thus, a horse that measures 60 inches is 15 hands high (15 × 4 = 60) and a horse halfway between 15 and 16 hands is 15.2 hands, or 62 inches tall (15 × 4 + 2 = 62) [5] [7] Because the subdivision of a hand is a base 4 system, a horse 64 inches high is 16.0 hands high, not 15.4. [2]
Viable hand geometry devices have been manufactured since the early 1970s, making hand geometry the first biometric to find widespread computerized use. [4] Robert Miller realized the distinctive features of hand sizes and shapes could be used for identification and patented the first automated hand geometry device at the Stanford Research Institute in 1971.
The digit, also known as digitus or digitus transversus (Latin), dactyl (Greek) or dactylus, or finger's breadth – 3 ⁄ 4 of an inch or 1 ⁄ 16 of a foot. [1] [2] (about 2 cm) In medicine and related disciplines (anatomy, radiology, etc.) the fingerbreadth (literally the width of a finger) is an informal but widely used unit of measure. [3] [4]
The related shaftment (1) and hand (2) were the width of the palm plus an open or closed thumb. The other units are the span (4) and finger (5). The palm is an obsolete anthropic unit of length , originally based on the width of the human palm and then variously standardized.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.
For example, one inch measured from a drawing with a scale of "one-inch-to-the-foot" is equivalent to one foot in the real world (a scale of 1:12)....one inch measured from a drawing with a scale of "two-inches-to-the-foot" is equivalent to six inches in the real world (a scale of 1:6).