Ads
related to: which buffing pad to use for wax guards on metal ceiling fansproducts.bestreviews.com has been visited by 1M+ users in the past month
- Shop our Gift Guide now
Need to Buy Someone Something?
We Have the Answers.
- Automotive Deals
Shop The Best Automotive.
Get Today's Best Deals.
- Shop our Gift Guide now
Search results
Results from the WOW.Com Content Network
Brasso has also been used to polish out scratches in plastics: It has been used to polish CDs, DVDs, screens, and pools to repair scratches. It is a mild solvent and an extremely fine abrasive, so when applied to the reflective surface of the disc and rubbed radially (in straight lines between the edge and centre), it can smooth scratches and reduce their effect.
One takes great care to remove any surface defects in the metal, like pits, that could allow bacteria to grow. A #4 dairy or sanitary finish is produced by polishing with a 180–240 grit belt or wheel finish softened with 120–240 grit greaseless compound or a fine non woven abrasive belt or pad.
The removal of oxidization (tarnish) from metal objects is accomplished using a metal polish or tarnish remover; this is also called polishing. To prevent further unwanted oxidization, polished metal surfaces may be coated with wax, oil, or lacquer. This is of particular concern for copper alloy products such as brass and bronze. [2]
Mill finish is the surface texture (or finish) of metal after it exits a rolling mill, extrusion die, or drawing processes, including sheet, bar, plate, or structural shapes. This texture is usually rough and lacks lustre; it may have spots of oxidation or contamination with mill oil.
Electropolishing, also known as electrochemical polishing, anodic polishing, or electrolytic polishing (especially in the metallography field), is an electrochemical process that removes material from a metallic workpiece, reducing the surface roughness by levelling micro-peaks and valleys, improving the surface finish.
Cleaning with a scouring pad. Toroidal scouring pad made of plastic wires, thus less aggressive to non-stick surfaces. A scouring pad or scourer is a small pad of metal or plastic mesh used for scouring a surface. Some scouring pads have one side made of a soft sponge-like material and the other is the aforementioned mesh.
The compounds are usually wax-based and can be applied by aerosol can, brush, low pressure pump up spray, or compressor fed spray gun. An alternative for sills/rocker panels is to block drain holes and simply fill them up with wax and then drain most of it out (the excess can be stored and reused), leaving a complete coating inside.
The process uses an abrasive and corrosive chemical slurry (commonly a colloid) in conjunction with a polishing pad and retaining ring, typically of a greater diameter than the wafer. The pad and wafer are pressed together by a dynamic polishing head and held in place by a plastic retaining ring.
Ads
related to: which buffing pad to use for wax guards on metal ceiling fansproducts.bestreviews.com has been visited by 1M+ users in the past month