Search results
Results from the WOW.Com Content Network
This is a list of commercially-available battery types summarizing some of their characteristics for ready comparison. ... 6,000–30,000 to 90% capacity Lithium iron ...
The most notable difference between lithium iron phosphate and lead acid is the fact that the lithium battery capacity shows only a small dependence on the discharge rate. With very high discharge rates, for instance 0.8C, the capacity of the lead acid battery is only 60% of the rated capacity.
The relationship between the Ah capacity and the discharge rate is not linear; as the discharge rate is increased, the capacity decreases. A battery with a 100 Ah rating generally will not be able to maintain a voltage above 10.5 volts for 10 hours while being discharged at constant rate of 10 amps. Capacity also decreases with temperature.
The rated capacity of a battery is usually expressed as the product of 20 hours multiplied by the current that a new battery can consistently supply for 20 hours at 20 °C (68 °F), while remaining above a specified terminal voltage per cell. For example, a battery rated at 100 A·h can deliver 5 A over a 20-hour period at room temperature. The ...
Capacity loss or capacity fading is a phenomenon observed in rechargeable battery usage where the amount of charge a battery can deliver at the rated voltage decreases with use. [ 1 ] [ 2 ] In 2003 it was reported the typical range of capacity loss in lithium-ion batteries after 500 charging and discharging cycles varied from 12.4% to 24.1% ...
Most manufacturers claim that overcharging is safe at very low currents, below 0.1 C (C/10) (where C is the current equivalent to the capacity of the battery divided by one hour). [23] The Panasonic NiMH charging manual warns that overcharging for long enough can damage a battery and suggests limiting the total charging time to 10–20 hours. [22]
The safe temperature range when in use is between −20 °C and 45 °C. During charging, the battery temperature typically stays low, around the same as the ambient temperature (the charging reaction absorbs energy), but as the battery nears full charge the temperature will rise to 45–50 °C.
For electrical motors, a similar kind of information is conveyed by the service factor, which is a multiplier that, when applied to the rated output power, gives the power level a motor can sustain for shorter periods of time. The service factor is typically in the 1.15-1.4 range, with the figure being lower for higher-power motors.